Menu
Sewing activewear / Sewing Activewear Tutorials / Sewing knits / Tutorials

Attaching eyelets on knit fabrics

How to add eyelets on knits

Adding eyelets (grommets) on stretchy knit fabrics can be a challenging as the fabric has a tendency to slip through after a while and several times I have ended up with a big hole and a loose metal ring. Not fun!

But I’ve come up with a method that is pretty solid and could in fact be used on all sorts of fabrics because it resists stress well.

For attaching eyelets on knit fabrics you’ll need
  • Firm non stretch fusible interfacing (I recommend Vlieseline H250)
  • A scrap of knit fabric (optional, but recommended when using thin knits)
  • Eyelets/grommets and suitable tools

eyelet-tutorial_024

1. Secure the fabric

Cut a circle of the interfacing, press it on the fabric and mark where the hole should be

 

eyelet-tutorial_025

2. Make a hole that is smaller than you would normally do

This is very important since knit fabric will grow a bit more even when interfaced so the hole should be smaller than you would have done on a woven fabric

 

eyelet-tutorial_027

eyelet-tutorial_026

3. Insert the eyelet

As you can see there some fabric around the edges of the. This is because the hole is a bit smaller. Too much fabric will make it hard for the washers to really fit in with the eyelets. And a hole that is too big will cause the fabric to stretch out and slip out of the eyelet. So there is a sweet spot for sure!

 

Eyelets on knits tutorial

4. Add a fabric scrap for extra insurance (optional)

This is important if you are working with a thin stretch knit, like rayon jersey. The eyelets needs some thickness to really “stick” to the fabric. So adding an extra layer is a good idea.

 

eyelet-tutorial_028

5. Add the washer

Don’t ask me which side should be up, I’m always confused! But I love Prym’s tutorials on YouTube, they are very clear on this subject.

 

eyelet-tutorial_029

6. Secure the washer to the eyelet

This is a pretty straight forward step. If you are using a hammer make sure it hits flat on the surface and I’ve also found that hammering with a firm but not super hard beat gives me the best result.

 

eyelet-tutorial_030

eyelet-tutorial_031

7. Inspection time

Don’t skip on this step, because this is an indicator of a successful assembly.

The eyelet should sit tight to the fabric on the right side, make sure there are no glitches.

The same goes for the washer on the wrong side, use your nails or a needle run through the entire edge to make sure it sits even and close.

striped-hoodie_015

There you go!

I hope this will be helpful for others, I’ve tried many different ways and this is the one that has worked the best. Plus a bonus tip; if you are attaching eyelets on a waistband made of thin knit, interface the side that is closest to body with a soft stretchy fusible since the metal might rub against or skin and could possible also wear down the fabric!How to sew eyelets on knits A sewing tutorial

 

9 Comments

  • PsychicSewerKathleen
    December 13, 2016 at 7:07 pm

    WOW Johanna again this was hugely helpful! I’ve never attached an eyelet but I know hoodies are in my future since I have such a difficult time getting a rtw that actually fits right with my rather abundant top 🙂 and narrower hip and there is no better way to secure the exit area of a tie than an eyelet. I wouldn’t have thought to interface and add an extra piece of fashion fabric either but it makes total sense. I’ll be bookmarking this page too! 🙂

    Reply
    • Johanna
      December 14, 2016 at 3:46 pm

      Agree, eyelets are great! Another option is machine stitched buttonholes, but they come with their own sets of challenges. I should do a tutorial on that too in the future! And stabilizing is everything when it comes to eyelets, and the same goes for snaps. I’ve had several RTW snaps rip because of poor stabilization. And all the best to your hoodie project, it sounds like a fun challenge!

      Reply
  • Lynsey
    December 18, 2016 at 9:53 am

    Great tutorial, thank you,. I will definitely come back to this when I’m ready to give it a try. I’m always nervous when it’s so final and can’t be undone but the result looks awesome.

    Reply
    • Johanna
      December 19, 2016 at 8:51 am

      You’re welcome! Just do a sample or two first to get feel of it, I still do that just to calm my nerves because as you say, the result is so final. I also add eyelets before I start sewing, so if I mess up I haven’t wasted a lot of time sewing only to not be able to use it. But eyelets are actually quite easy to attach!

      Reply
  • Sporty Fleece Jacket | Last Stitch
    April 2, 2019 at 4:26 pm

    […] Eyelet tip: Attaching eyelets on stretchy knits can easily end up with fabric slipping out when stretched. Not fun! Luckily I have devised a bulletproof method for doing this, and blogged about it too! How to attach eyelets on stretchy fabrics  […]

    Reply
  • Jojo Sewist
    November 15, 2019 at 8:51 pm

    Talented Lady, is there any part of making your own clothing you cannot do? Does any of it intimidate you? Do you have any tips for purchasing fabric online? Seems I am never happy w/the fabric regardless of the price. Help, because of this I am ready to give up sewing after 50+ years.

    Reply
  • […] you rather add eyelets than sewing buttonholes? You can check out my attaching eyelet on knits tutorial for best practises but I would not reccommend using eyelets on super stretchy activewear fabrics, […]

    Reply
  • Julie
    June 6, 2020 at 5:20 pm

    Where did you get your grommet kit?

    Reply
  • Gemam
    July 12, 2020 at 7:35 am

    Any solutions for when you read this after a disaster hole has occurred!!

    Reply

Leave a Reply